Author Topic: Cross Hatch sanding technique (Read 7516 times)

stopncrank · « **on:** December 02, 2011, 03:17:36 AM »

Is there a chart available or maybe someone can explain in laymans terms how to do this? Example, holes up, holes down and so on...

Also, good points and bad points about this sanding process for a higher rev player, and how it works for different strenghts of equipment?

Thanks,

Stop

Still taking your lunch money one strike at a time, just without a Mission in my bag....

ImBackInTheGame · « **Reply #1 on:** December 02, 2011, 11:23:40 AM »

I usually only do 4 sides (6,5,3,4 in the picture above) but 6 sides is recommended by some.

MK · « **Reply #2 on:** December 02, 2011, 12:41:59 PM »

I also do 4 side just like what back in the game says:

Pin Up
Pin Down
Pin hotizontal with fingerholes pointing up
Pin horizontal with fingerholes pointing down

MK

Aloarjr810 · « **Reply #3 on:** December 02, 2011, 02:23:33 PM »

Cross Hatch sanding

is where the sanding lines are at 90 degrees to each other. It would be like sanding a piece of wood lengthwise and then doing it again crosswise. the point is not to sand the original sanding grooves out the second time, but to create cross groves.You basically are doing the 4 side sanding

Now according to the Bowling Ball Parts and Dynamics (pg: 6-20) manual, you would sand the entire ball parallel to the ball track first.Then rotate the ball 90 degrees to create the cross hatch.

You can see this manual here:

http://www.athletics2000.com/andrew/Documents/USBC%20Bowling%20Ball%20Parts%20and%20Dynamics.pdf

For more sanding pattern info see here also:

http://www.jayhawkbowling.com/Pro_s_Corner/Resurfacing_Tips/resurfacing.html

Aloarjr810
----------
Click For My Grip

Edited by Aloarjr810 on 12/2/2011 at 3:30 PM

Author Topic: Cross Hatch sanding technique (Read 7516 times)

stopncrank

Cross Hatch sanding technique

ImBackInTheGame

Re: Cross Hatch sanding technique

MK

Re: Cross Hatch sanding technique

Aloarjr810

Re: Cross Hatch sanding technique