win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Break Pearl Vs. Other Peals on the market?  (Read 1846 times)

Ramtart

  • Hero Member
  • *****
  • Posts: 1658
Break Pearl Vs. Other Peals on the market?
« on: April 02, 2008, 06:48:46 AM »
Hey BR Family,

I'm receiving a Break Pearl today and will be laying it out/drilling it up next week.

For those of you who have this ball, how does it compare to your other Asymmetric Pearls with similar layouts?

My stats are in my profile. This will be my strong pearl in my lineup.

Thanks!
Rammy
--------------------
Rample Stiltskin
"Tag Team Coaching success story"

Team Butigroove!!!
Logged

 

revTrex

  • Hero Member
  • *****
  • Posts: 1354
Re: Break Pearl Vs. Other Peals on the market?
« Reply #1 on: April 02, 2008, 03:05:13 PM »
Similar length as the Gravity Shift with a slightly more angular move...about the same boards covered, but for me, a more useable ball on a wider variety of patterns.


--------------------
www.900global.com

www.bowlersjournal.com
Logged

novawagonmaster

  • Hero Member
  • *****
  • Posts: 4279
Re: Break Pearl Vs. Other Peals on the market?
« Reply #2 on: April 02, 2008, 03:35:26 PM »
My Break Pearl and Complete NV are very close.
They both have the same layout (rico).
The Complete NV is 1 or 2 borads stronger and slightly more angular.
That said, I like throwing the Break Pearl better. I just get such a good read with this ball!

--------------------
Jon (in Ohio)
aka: Rico Swerve~

Logged

230-n-up-or-bust

  • Hero Member
  • *****
  • Posts: 5381
Re: Break Pearl Vs. Other Peals on the market?
« Reply #3 on: April 02, 2008, 07:52:23 PM »
I had quite an afternoon with mine.  Killed the hole.  Slaughtered it in fact.  Too hard.  I'm gonna knock off some of the shine with a gray scotch brite to see if I can transfer a little of the backend motion to an earlier midlane read.  Mine is drilled 5.25" pin to pap(directly over bridge) with the mb @ 75 degrees and a fourth hole in the thumb quadrant about 2 inches below my PAP along the PAL.  Moves a LOT more than I expected.  I can only imagine how this ball reacts for me with a stronger drilling.  I'm gonna get one with a drilling closer to 4.5" pin to pap and a hole just an RCH past my PAP.

Good luck with yours.  Were it not for the Cell, this would be the BOTY.
--------------------
The task ahead of us is never as great as the power behind us.

Me

MTIXE

Charter member of the Cartel for Eradication of Avenging Unicorns
Logged
Pages: [1]
« previous next »