win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: AMF Drilling  (Read 2124 times)

RealBowler

  • Hero Member
  • *****
  • Posts: 722
AMF Drilling
« on: July 21, 2005, 11:29:26 AM »
Does anybody have any good drilling instructions for the the AMF asymmetric balls?  I'm going to be getting a Max Velocity in a few days, but the drill sheet on the site is the same for their symmetric and asymmetric balls.
--------------------
Haywood

**************************
I don't need a stupid
signature. This is enough.
**************************
Logged

 

charlest

  • Hero Member
  • *****
  • Posts: 24526
Re: AMF Drilling
« Reply #1 on: July 21, 2005, 07:54:09 PM »
quote:
Does anybody have any good drilling instructions for the the AMF asymmetric balls?  I'm going to be getting a Max Velocity in a few days, but the drill sheet on the site is the same for their symmetric and asymmetric balls.
--------------------
Haywood
**************************


I believe that is because their mass bias or intermediate differential is not large. I am not 100% sure about that but about 95% sure. I'd be inclined to treat it like a symmetric core UNLES I wrote to AMF about a particular ball and its core and heard otherwise.

I'd strongly suggest writing to them or message a userid, Pat_Nolan .I blieve he is an AMF technical person.
--------------------
Bowling: Just like hand grenades and horse shoes, you only have to get close.
Life: Deal with what is.
Logged
"None are so blind as those who will not see."

bigearv14

  • Hero Member
  • *****
  • Posts: 1545
Re: AMF Drilling
« Reply #2 on: July 21, 2005, 08:31:16 PM »
i have the MV and velocity, both drilled pin right of ring, MB 2" right of thumb. but make sure you dull the MV. if not, it has too much over/under.
--------------------
AMForce...either you're with us or against us!!!!
Logged
Pages: [1]
« previous next »