Author Topic: Who has a Time Zone? (Read 1303 times)

agroves · « **on:** May 18, 2004, 09:10:58 AM »

I picked up a used TZ from stikinmachine. The pin is under the ring, so it comes to 4 3/4 from my axis. The mb is on Val. Has anyone had luck with this drilling? How is yours drilled? Do you like? Looking for good suggestions.

Andrew
--------------------
FUFU

If you're an idiot, you can join my ignore list

LuckyLefty · « **Reply #1 on:** May 19, 2004, 01:12:39 AM »

Very BORING reaction!!! But I just keep scoring well with it!

BORING!!!

REgards,

Luckylefty
PS now this ball drilled stacked, why that's another animal!

LuckyLefty · « **Reply #2 on:** May 21, 2004, 05:18:00 AM »

Again this ball is very drilling oriented!

A friend with no backend type hand.(up the back) drilled 4 X 5. Mass bias under thumb. I never saw so much backend.

Me the opposite a ton of backend! With this ball very smooth and WILL strike if the surface doesn't carry it down too far!

REgards,

Luckylefty

agroves · « **Reply #3 on:** May 21, 2004, 10:03:43 AM »

LL,

I have a TZ and Ravage, these are my only two assymetrical core balls. I think if I drill the TZ with the pin under the ring, mb on val with a smooth grit sand. Then, I take my new Ravage, drill it 2 1/2 p2p, mb just right of thumb about 5 3/4 inches and leave the high gloss polish. That would give me a nice 1, 2 punch.

Since it is raining today I guess my golf lesson isn't happening. Oh well, I will go bowling instead.

Andrew
--------------------
FUFU

If you're an idiot, you can join my ignore list

Author Topic: Who has a Time Zone? (Read 1303 times)

agroves

Who has a Time Zone?

LuckyLefty

Re: Who has a Time Zone?

LuckyLefty

Re: Who has a Time Zone?

agroves

Re: Who has a Time Zone?