win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: UI Changed Drilling  (Read 1171 times)

Supermo

  • Sr. Member
  • ****
  • Posts: 279
UI Changed Drilling
« on: May 12, 2005, 09:55:36 AM »
I had my UI drilled this way and didn't get much of a finish
==0==0=*
====+==
====0==
Pin* CG
Now I'm having it done like this with a weight hole
       
==0==0=*
========+
====0===
Will i see a difference..Thanks guys


   

Hit em thin watch em Spin


Edited on 5/12/2005 6:00 PM
Logged

 

Supermo

  • Sr. Member
  • ****
  • Posts: 279
Re: UI Changed Drilling
« Reply #1 on: May 13, 2005, 11:12:37 AM »
Thanks for the info guys, i didn't do the sketch very good. On the first drilling the CG was less than 2ins from the pin, on the 2nd drilling which i hope to have it will be over 3 ins and the pin will be about an inch above the ring finger. Hope this helps you to revise your observations.
--------------------


Hit em thin watch em Spin
Logged

Supermo

  • Sr. Member
  • ****
  • Posts: 279
Re: UI Changed Drilling
« Reply #2 on: May 18, 2005, 04:25:52 AM »
Hi guys
Had my UI redone to this drilling.. see post.
=======+      
==0=0======*
======#
===0==
Pin+ cg# X/hole*
Pin 1/half ins to the right of ring finger and 3/4in above
CG 2/1/2 to the right of middle. My X hole is 4/half ins to the right of the pin and 1/2inch below, shortened the span by 3/16 felt more comfortable.
Played last night had a 199 1st game moved a little deeper had 242 263 for a 704.
Saw a big difference in the finish much snappier had a lot of boards to play with. When i get my AI should i have the same or would you suggest a different drilling.
--------------------


Hit em thin watch em Spin

Edited on 5/18/2005 4:18 AM

Edited on 5/18/2005 4:55 PM

Edited on 5/18/2005 4:56 PM
Logged
Pages: [1]
« previous next »