win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: ball surface  (Read 2078 times)

rico4life

  • Full Member
  • ***
  • Posts: 227
ball surface
« on: December 10, 2014, 11:45:28 PM »
I have a question about ball surface on Brunswick equipment, I have a aura mystic and a mastermind, both are polished. I am having problems with both hooking way to much and kinda of inconsistent, would taking surface down actually make them hook less because they are burning up sooner or not storing as much energy.
Logged

 

charlest

  • Hero Member
  • *****
  • Posts: 24526
Re: ball surface
« Reply #1 on: December 11, 2014, 05:23:21 AM »
Not usually.
Taking the surface from polished (normally in the 5000+ grit range) to 3000 or 4000 grit will make the ball hook earlier and be more consistent, but it will tend to hook slightly more overall. Not a lot, but as you go down in grit numbers (rougher surface), the ball will hook earlier and earlier and require more oil to conserve energy. However at 4000 grit, the increase in hook will generally be minimal. It's a good and safe first step.
Logged
"None are so blind as those who will not see."

Brunswick_fan_BrandonH

  • Hero Member
  • *****
  • Posts: 786
Re: ball surface
« Reply #2 on: December 12, 2014, 11:22:34 AM »
Like charlest said, if you just take a 4000 pad to what the current surface is now with the polish, it would be a little smoother reaction overall.

If they are hooking way too much downlane, then putting surface on the ball will cause it to be smoother on the back. If they are hooking too much overall, then a surface adjustment might help by using up some of the energy earlier and not storing it.

If it is too much overall hook, then you could use 500-2000-rough buff or royal compound to help smooth out the 500 underlying grit. And, if it is still too much, then you could use 500-1000-2000-rough buff or royal compound. Using the Royal compound, it won't snap as hard compared to polishing it because it has about a 3000 grit surface in the formula.
Logged
Vise Staff Member

rico4life

  • Full Member
  • ***
  • Posts: 227
Re: ball surface
« Reply #3 on: December 15, 2014, 01:20:09 AM »
I hit my mastermind with 4000 pad before league Friday, didn't seem to change it too much but as night went on I noticed that it was much smoother and calmer off the spot much more controllable.
Logged
Pages: [1]
« previous next »