win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Drilling Nexus Solid  (Read 1773 times)

kong1

  • Full Member
  • ***
  • Posts: 169
Drilling Nexus Solid
« on: November 17, 2011, 04:55:44 PM »
 I'm getting a Nexus solid drilled up today and was wondering if getting it drilled pin up will cause it to go to long. Everyone seems to say this ball doesn't hook early but I have better luck with pin up drillings because of not much tilt. My best drilling seems to be with a pin 4 1/2- 5 inch pin to pap and mb kicked out. Would that be a good choice for this ball.

Logged

 

dizzyfugu

  • Hero Member
  • *****
  • Posts: 7606
Re: Drilling Nexus Solid
« Reply #1 on: November 18, 2011, 01:34:22 AM »
IMO, go with it when the layout basically works for you and adjust the surface as needed.

You might also later add a balance hole to promote an earlier reaction, if needed.


DizzyFugu - Reporting from Germany
2010/11 Benrather BC Club Champion
Confused by bowling? Check out BR.com's vault of wisdom: the unofficial FAQ section
Logged
DizzyFugu ~ Reporting from Germany

BrunsNick

  • Brunswick Rep
  • Hero Member
  • *
  • Posts: 7306
Re: Drilling Nexus Solid
« Reply #2 on: November 18, 2011, 03:13:49 AM »
Go for it. If you like pin up layouts, then you'll love this one.


Nick Smith - Brunswick Product Specialist
www.BrunsNick.com
www.BowlwithBrunswick.com
www.Facebook.com/brunswick.bowling
www.DV8Bowling.com
www.Facebook.com/dv8bowling
We like you so you should like us!
Logged
Nick Smith
Digital Media Manager - Brunswick Bowling
http://www.brunswickbowling.com
http://www.youtube.com/c/brunsnick

kong1

  • Full Member
  • ***
  • Posts: 169
Re: Drilling Nexus Solid
« Reply #3 on: November 18, 2011, 04:53:06 AM »
 sounds good. I think I am going to like this ball from what everyone is saying about it. Alot of times when I throw a heavier oil ball they don't save much for the backend.

Logged

Russell

  • Hero Member
  • *****
  • Posts: 5121
Re: Drilling Nexus Solid
« Reply #4 on: November 18, 2011, 07:05:10 AM »
I agree with all above...this ball does really well with surface adjustments.  I drilled mine 5" pin high 5" MB and it's still extremely aggressive.  I had to take the surface off of it to throw it on the China (not very much oil), but in other centers where there is volume it's a monster.

Little known fact:  In Russian "Hope" and "Change" translate to "Tax" and "Spend"
Logged
Pages: [1]
« previous next »