BallReviews
Equipment Boards => Brunswick => Topic started by: rymacatthedisco on February 21, 2007, 05:42:04 PM
-
i just wanted to no if ne of the brunswick guys out there have ne good ideas on how to drill this thing...im not a brunswick fan i only have a vapor zone otherwise i dont care for the stuff, but im giving this a try and i want to make the best of it...i throw the ball about 16-17 mph, prob 300-350 revs, my ball tracks next to my thumb by bout an in and i like to play inside....i want this thing to be able to hook a ton on heavy oil but i dont want it to just roll and hit, ive found that drillings like that just dont carry...so let me no wut everyone thinks it would greatly appreciated!!!
--------------------
RYAN MCDANIEL...Northern Illinois University bowling
-
I'd say pin up above the bridge 4 1/2 - 5" from axis, no hole. I've been finding that higher pin locations tend to open up the flare rings on this ball.
--------------------
Nick Smith ... A.K.A. Les Badderâ„¢
Brunswick -=- PBA 03-07
http://www.BrunsNick.com
http://www.BigBapparel.com
¡Viva la nación de Brunswick!
-
how does the fury compare to the scorchin inferno?
-
Drilled mine pin next to ring finger. I am seeing many flare rings only about 1/4 in apart. Is this bad?
-
ONLY 1/4" apart?
You're fine. 
--------------------
Nick Smith ... A.K.A. Les Badderâ„¢
Brunswick -=- PBA 03-07
http://www.BrunsNick.com
http://www.BigBapparel.com
¡Viva la nación de Brunswick!
-
Kick the cg over so that you have no more than 7/8's side. This gives you pro shop obtions to put a xhole to tweak the reaction. This ball is very aggressive so the high pin postion I would reccomend also.