BallReviews

Equipment Boards => Brunswick => Topic started by: dev on May 25, 2005, 02:23:06 PM

Title: how am i gonna drill up my UI?
Post by: dev on May 25, 2005, 02:23:06 PM

I'm looking into drilling my UI for heavy condition, with a strong arc reaction.. how should I drill it? hope my profile can provide you the way i play.

Anyway, if I shine up my UI is it possible for it to skid/snap or possible for a strong arc?

Thanks in advance!

Title: Re: how am i gonna drill up my UI?
Post by: dev on May 26, 2005, 01:16:38 AM

Err..

okay, how do I drilled that ball for outside lines?

Title: Re: how am i gonna drill up my UI?
Post by: dev on May 26, 2005, 05:02:41 AM

no one?!


I'm just askin whether this ball could be drilled for outside lines on heavy conditions.

Title: Re: how am i gonna drill up my UI?
Post by: Sir Bowl-A-Lot on May 26, 2005, 09:16:41 AM

Heavy condition with a strong arc eh?

Put the pin below your ring finger (or below and between both fingers) and swing the CG out to the right about an inch or two from the center of your grip (if you're a righty).  In order to achieve this drilling, buy an Ult. Inferno with a 2-3" pin.  Just my .02
--------------------
*Don't swing it if you can't bring it.*
"Hey Guero..." "Yeah, bro?"
BallReviews member since 3/31/2003 (since 2001 under the late user name buzzsaw16)

Edited on 5/26/2005 9:09 AM

Title: Re: how am i gonna drill up my UI?
Post by: dev on May 26, 2005, 09:16:49 PM

Thank you very much!