BallReviews

Equipment Boards => Brunswick => Topic started by: strikestriketapped on April 27, 2008, 12:30:02 PM

Title: How to drill my Avalanche Pearl?
Post by: strikestriketapped on April 27, 2008, 12:30:02 PM

I ordered an Avalanche Pearl with a 3-4" pin and 2.5-3.0 TW. I'm hoping that this ball will fit well under the Twisted Fury, be good for med/light, but have more length. My PAP is 4.5" over and 3/8 up. I was thinking of drilling it 5" from my PAP, pin above the fingers. Would this be a good idea?

Title: Re: How to drill my Avalanche Pearl?
Post by: strikestriketapped on April 28, 2008, 06:39:13 PM

ttt

Title: Re: How to drill my Avalanche Pearl?
Post by: lilmike2782 on April 28, 2008, 06:42:49 PM

pin above the bridge.  that is how mine is drilled and it fits under my twisted that is drilled the same.
--------------------
ultra zone
hammer toxic
twisted fury
hot rod hybrid
kick zone
avalanche pearl
clear golf ball

Title: Re: How to drill my Avalanche Pearl?
Post by: John D Davis on April 28, 2008, 06:43:43 PM

This thing goes for days drilled like this... I wouldnt drill it for length such as being 5" from pap because it may not react hardly at all. But, however, if you drilled it real strong then it may compliment the twisted... I have a power groove with the pin under the middle finger and then the P Avalanch like you sugested with the pin above the fingers and they both react very similar, if that helps you any.

Title: Re: How to drill my Avalanche Pearl?
Post by: strikestriketapped on April 28, 2008, 07:29:34 PM

Inverted, I will be placing the pin in the same spot as the Twisted. Thanks.