BallReviews
Equipment Boards => Brunswick => Topic started by: Shifter on December 14, 2003, 08:11:31 PM
-
For those following along, this is supposed to fit inbetween my raging, and my frenzy.
Raging Layout: 15#, 3" pin, (3 3/4 X 5) pin along side and a hare low of ring finger (label leverage), 0 top, even on side...
Frenzy layout: 15# 3.5" pin, (5 X 4.5) pin above ring, little top left, and 1/2 oz positive side.
I was thinking of laying out the inferno similar to the Frenzy, and letting the cover and core do the work.....
I notice that Barnes keeps the pin right above the bridge, I assume for more control?
thoughts?
thank you!
-
if you like the RI drill, go with that........other than that, it's going to depend on if you're looking for a specific read/reaction off of it.....
--------------------
JEFF