win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Polish Absolute inferno  (Read 1052 times)

high_revs

  • Full Member
  • ***
  • Posts: 210
Polish Absolute inferno
« on: March 07, 2005, 07:30:44 AM »
I want to polish my AI to get more length but i don't want it to become to snappy (over/under reaction).  Is there a way to do this?  If so, what should i use? thanks
Logged

 

tburky

  • Hero Member
  • *****
  • Posts: 1071
Re: Polish Absolute inferno
« Reply #1 on: March 07, 2005, 08:23:52 PM »
I used a little bit of ebonite factory finish polish (did not have any brunswick polish)on my absolute inferno. Ball gets good length and corners strong. I did a lengthy layout using a 4" pin out.
Logged

BowlersAidProShop-Wells

  • Sr. Member
  • ****
  • Posts: 343
Re: Polish Absolute inferno
« Reply #2 on: March 07, 2005, 11:15:39 PM »
Unless you drilled it to be extremely flippy to begin with, dont worry about putting polish on it.  Its a low rg/high diff. ball, so its going to get into a roll when encountering friction.  Think of it almost like polishing a V2 Sanded.  The ball is still a great midlane reading control ball, very rarely have I seen that give over/under. So, after all that, POLISH AWAY
Logged
Pages: [1]
« previous next »