BallReviews

Equipment Boards => Brunswick => Topic started by: PowrKoil17 on May 13, 2011, 08:37:00 AM

Title: Power Groove Red/Teal Pearl vs. Sapphire Pearl
Post by: PowrKoil17 on May 13, 2011, 08:37:00 AM
with the addition of a weight hole can i make my PG stronger than my Sapphire Pearl. i need something weaker than my Sapphire Solid but a little stronger than my Sap Pearl.

Thank God my Son bowls so I can have a Hero!
 
Power Groove DryR
Red/Teal Pearl Power Groove
Sapphire Zone Pearl
Sapphire Zone Solid
Control Zone
Title: Re: Power Groove Red/Teal Pearl vs. Sapphire Pearl
Post by: kidlost2000 on May 14, 2011, 01:49:58 AM
Maybe, probably, or no.

 

If the PG is undrilled you can try drilling it differently from your pearl to be earlier, or more angular. If it is already drilled you can try adjusting the surface and adding a weight hole to get the desired reaction. With out knowing how all three are drilled it is really hard to guess. The more information given, the more educated the guess.


Be good, or be good at it.
Title: Re: Power Groove Red/Teal Pearl vs. Sapphire Pearl
Post by: PowrKoil17 on May 14, 2011, 07:44:56 AM
The PG is drilled pin up stacked, the Sap Pearl is drilled pin to the right of fingers with Cg towards the palm. The Solid is drilled very similar to the pearl with the exception it has a weight hole.

Thank God my Son bowls so I can have a Hero!
 
Power Groove DryR
Red/Teal Pearl Power Groove
Sapphire Zone Pearl
Sapphire Zone Solid
Control Zone
Title: Re: Power Groove Red/Teal Pearl vs. Sapphire Pearl
Post by: kidlost2000 on May 14, 2011, 12:45:28 PM
So how does the Pearl roll vs the PG?

Be good, or be good at it.
Title: Re: Power Groove Red/Teal Pearl vs. Sapphire Pearl
Post by: PowrKoil17 on May 14, 2011, 08:27:09 PM
the Pearl rolls a little sooner than the PG. 

Thank God my Son bowls so I can have a Hero!
 
Power Groove DryR
Red/Teal Pearl Power Groove
Sapphire Zone Pearl
Sapphire Zone Solid
Control Zone
Title: Re: Power Groove Red/Teal Pearl vs. Sapphire Pearl
Post by: kidlost2000 on May 15, 2011, 05:05:01 AM
If your wanting the PG to be sooner then the pearl I would try and go with some surface adjustments. With out seeing all three in action it is hard to tell how much difference there is between the three bowling balls. Or you can just add a weight hole and see what happens. Depending on the location will determine the reaction. My first choice would be the surface.

Be good, or be good at it.