win a ball from Bowling.com

Author Topic: Question about my Ultimate Inferno  (Read 1625 times)

TripleJay22

  • Newbie
  • *
  • Posts: 4
Question about my Ultimate Inferno
« on: June 21, 2009, 08:41:15 AM »
so this past season was my first season and about mid way thru i got an ultimate inferno and have since been getting better with it being able to hook, and it has seemed to lose its hook that it once had, i have cleaned it multiple times with water/soap on the sink, etc is there anything else i can do to get that hook back?

 

  • Guest
Re: Question about my Ultimate Inferno
« Reply #1 on: June 21, 2009, 04:50:54 PM »
Find a shop with a Revivor and have the oil extracted, followed by a light resurfacing. That ball's reaction will bounce right back.


--------------------
Lane Carter, Strike Zone Pro Shops - Salt Lake City, Utah
Brunswick Pro Shop Staff

www.brunswickbowling.com

The opinions expressed are solely those of the writer and not of Brunswick Corporation.

TripleJay22

  • Newbie
  • *
  • Posts: 4
Re: Question about my Ultimate Inferno
« Reply #2 on: June 21, 2009, 04:57:58 PM »
ok and also I bowl at two different alleys, one i just go to becuase its close and it seems to still hook just fine there but when I go to the alley where my league is at it doesnt seem to do it. and they said its a heavy oil set up at that alley.

TripleJay22

  • Newbie
  • *
  • Posts: 4
Re: Question about my Ultimate Inferno
« Reply #3 on: June 21, 2009, 10:28:19 PM »
So I went bowl today and haven't had a chance to get it refinished yet but it seems to begin to hook and then just goes straight

  • Guest
Re: Question about my Ultimate Inferno
« Reply #4 on: June 21, 2009, 10:45:23 PM »
It could be hitting carry-down, or it could be "rolling out" if it hits friction too soon.
Get the oil pulled out of the cover and a light resurface done because it's probably overdue anyway, then we can take it from there.


--------------------
Lane Carter, Strike Zone Pro Shops - Salt Lake City, Utah
Brunswick Pro Shop Staff

www.brunswickbowling.com

The opinions expressed are solely those of the writer and not of Brunswick Corporation.

drifter106

  • Jr. Member
  • **
  • Posts: 21
Re: Question about my Ultimate Inferno
« Reply #5 on: June 21, 2009, 11:55:22 PM »
Have the same ball and follow you when you talk about removing oil.  In regards to giving it a "light" resurface how would you go about it.  I do have access to a ball spinner but not sure what steps to follow with the resurfacing or what weight of pad(s) to use.  

thanks
--------------------
What is common knowledge to some, is a revelation to others...

  • Guest
Re: Question about my Ultimate Inferno
« Reply #6 on: June 22, 2009, 08:23:17 AM »
Don't underestimate the value of the Revivor to remove oil first. Then if the cover isn't beat up too bad, I would probably start around 500 and go to 1000, 2000, whatever you like the finish to be. You can also use lighter hand pressure. However, if there's lots of track wear you might start at a lower grit, then 500, then your finishing grit.

I like to use lots of water, and adjust speeds to smooth out the cover. Good luck.




--------------------
Lane Carter, Strike Zone Pro Shops - Salt Lake City, Utah
Brunswick Pro Shop Staff

www.brunswickbowling.com

The opinions expressed are solely those of the writer and not of Brunswick Corporation.