BallReviews

Equipment Boards => Brunswick => Topic started by: notsohotshot on April 14, 2009, 01:11:42 PM

Title: rattler
Post by: notsohotshot on April 14, 2009, 01:11:42 PM

What has been the most successful drilling for the Rattler for you rev dominate semi-crankers out there?

Title: Re: rattler
Post by: TheDude on April 14, 2009, 10:10:10 PM

something with the pin around 4 1/2 to 5 inches away. cg just about anywhere it doesnt really matter.
--------------------
Timothy @Juniors Pro-Shops
LaSalle, Quebec-Located inside Pont Mercier Lanes.
Edmonton, Alberta. -Located inside Ed's Rec Room.(WEST ED MALL)
Keep them honest!

Ebay store updated very often: http://stores.ebay.com/gumby3170

Title: Re: rattler
Post by: LowRG on April 15, 2009, 07:26:50 AM

Well, I guess I fall into that category.  I drilled mine with about a 4" pin under my RF. With the stock finish, it was very angular, even with a rolly, aggressive layout. I knocked the polish off and put the ball to 2000 grit, and teh ball is what i was looking for.  Smooth all over yet easy to get down the lane.

Title: Re: rattler
Post by: LaneHammer20 on April 15, 2009, 07:49:01 AM

mine looks amazing with a modified rico drill on it. Good length strong midlane, assertive backend motion
--------------------
What is sandbagging???

Title: Re: rattler
Post by: on April 15, 2009, 09:23:49 AM

I'm far from a cranker, but mine's drilled Rico and I love it.


--------------------
Lane Carter, Strike Zone Pro Shops - Salt Lake City, Utah
Brunswick Pro Shop Staff

www.brunswickbowling.com

The opinions expressed are solely those of the writer and not of Brunswick Corporation.