i would like to publicly thank tom tomaras and the entire r&d staff at brunswick for all their help over the past several years. these guys have helped me with everything from ball selection, drilling suggestions, coverstock preparation, and ball maintenence. most recently, tom gave me some advice that really paid off tonight. he recommended heating out the oil of my inferno with a blow dryer in a cardboard box and it really made a noticeable difference. after wetsanding the ball down to 600 grit i placed the ball in the box for 10 minutes and wiped off the oil with windex and paper towels. i repeated this process for three(3) cycles until no noticeable about of oil remained. i then thouroughly cleaned the ball one last time with windex and wetsanded the ball 800 and then finally 1,000 grit. i have not seen this much reaction in my inferno in quite a while---and this ball was purchased last year at this time. tonight i shot 786( 259, 258, 269 )playing a down and in shot around 7-8. i plan on trying this method of oil extraction on my raging inferno and monster slayR when it's needed but until then thank you tom and the r&d staff at brunswick.