BallReviews
Equipment Boards => Brunswick => Topic started by: Dewey24 on February 16, 2009, 04:47:53 AM
-
I recently purchased the Twisted Fury Destruction and drilled it 5' Pin to PAP below and between my fingers with the MB about an inch to the right and low of the thumb. The original pin to Cg distance was about an inch. I love this ball and have been scoring very well with it when owner error doesn't get in the way. I would like to pick up a Rattler and drill it the same way, but was wondering if it would be too much of an over lap and end up being a waste.
The truth of the matter is I never see the oil amounts to justify heavy oil or strong drilling balls. Really looking for something for once the lane breaks down and I can't control the TFD anymore. As always thank you for any help and suggestions.
Edited on 2/16/2009 4:21 PM
-
The Rattler will get down lane further than the TFD. For me the Rattler is stronger off the spot and allows me when playing deep to still get the corners out.
--------------------
BRUNSWICK ADVISORY STAFF
VISE REGIONAL STAFF
-
you should put a different drilling on the rattler. i dont see why you wouldn't unless you want two balls with similar reactions
--------------------
Drew Jordan
Columbus, OH
-
the rattler will allow you to play deeper, and still get it to turn the corner and carry. For me, tha assymetric torsion core has to be played closer to friction or carry suffers
--------------------
My Arsenal:
Bounty(4.5 x 4.75 Fresh 1000 Abralon)
Twisted Fury(5 x 4 500 Abralon + Reacta Shine)
Raw Hammer Pain(Leverage 1000 Abralon)
Blue Vibe(5 x 5 4000 Abralon + Reacta Shine)