BallReviews

Equipment Boards => Brunswick => Topic started by: agroves on May 18, 2004, 09:10:58 AM

Title: Who has a Time Zone?
Post by: agroves on May 18, 2004, 09:10:58 AM

I picked up a used TZ from stikinmachine.  The pin is under the ring, so it comes to 4 3/4 from my axis.  The mb is on Val.  Has anyone had luck with this drilling?  How is yours drilled?  Do you like?  Looking for good suggestions.

Andrew
--------------------
FUFU
If you're an idiot, you can join my ignore list

Title: Re: Who has a Time Zone?
Post by: LuckyLefty on May 19, 2004, 01:12:39 AM

Very BORING reaction!!!  But I just keep scoring well with it!

BORING!!!

REgards,

Luckylefty
PS now this ball drilled stacked, why that's another animal!

Title: Re: Who has a Time Zone?
Post by: LuckyLefty on May 21, 2004, 05:18:00 AM

Again this ball is very drilling oriented!

A friend with no backend type hand.(up the back) drilled 4 X 5.  Mass bias under thumb.  I never saw so much backend.  

Me the opposite a ton of backend!  With this ball very smooth and WILL strike if the surface doesn't carry it down too far!

REgards,

Luckylefty

Title: Re: Who has a Time Zone?
Post by: agroves on May 21, 2004, 10:03:43 AM

LL,

I have a TZ and Ravage, these are my only two assymetrical core balls.  I think if I drill the TZ with the pin under the ring, mb on val with a smooth grit sand.  Then, I take my new Ravage, drill it 2 1/2 p2p, mb just right of thumb about 5 3/4 inches and leave the high gloss polish.  That would give me a nice 1, 2 punch.  

Since it is raining today I guess my golf lesson isn't happening.  Oh well, I will go bowling instead.

Andrew
--------------------
FUFU
If you're an idiot, you can join my ignore list