My Vapor Zone is drilled 3 3/8s Pin to PAP with a Hole somewhere around my PAP (Not sure where but I do believe it's to increase flare). The Ball is over flaring. If I plugged it and drilled it weaker would the effects of the hole still have an effect on the ball?

Guess I'll never know lol

Short answer: maybe.

The details are a little incomplete to give an accurate answer.

1.) You don't seem to know for sure if it is a flare increasing x-hole.
2.) It's unclear whether you originally meant a full replug, or a plug of the finger/thumb but leave the x-hole, or plug the x-hole only.

I'll expound a little on #2 above:
- A full replug would rather obviously allow you to reduce flare potential. I kinda didn't think you meant this one anyway.
- Plugging the x-hole only would allow you to opt for a flare reducing x-hole, which would most likely keep you from over-flaring.
- If plugging only the gripping holes, but leaving the original x-hole, we can't definitively give you a response, without knowing your PAP, the actual location of the original x-hole, and the pin distance above midline. It's entirely possible to keep the x-hole in the flare increasing position, but raise or lower the pin; to alter the layout and land the original x-hole on your axis; or even, depending on your axis measurements, increase the pin to PAP distance and land the original x-hole in a flare reducing position.

Need more info.

A full replug at 4.5" P2P with no x-hole would flare a lot less than your current drilling.

Edit: I never mentioned that, originally, at 3-3/8" P2P + flare increasing hole, you're beyond the limits of the track flare effect. With that in mind, just going from 3-3/8" to 4.5", may not quite give you the length you're looking for. You might consider going on out to 5" or 5.5".

Edited on 4/25/2007 4:59 PM