I have both a Momentum and a Rival, they are both drilled Pin to PAP of 4", under the ring, cg 3" from PAP.  My Momentum is a great ball, shot 300 in my state tourney, and the surface is at 4000 abralon with no polish.  It gives me very, very, good length with a strong continuos backend.  Great ball for medium blend house shot, and the Viper.

My question is this:  What surface should I go with on my Rival?  I want the ball to be stronger in the midlane than my Momentum, but still have a good backend move.  When the Momentum starts to push a little, or leave some flat coners, I want to be able to switch right over to the Rival and pick up where the Momentum left off.  I was thinking about going 1000 abralon with Finesse-It II polish.  Any suggestions would be greatly appreciated.  My bios are in my profile, thanks.
--------------------
MainePBA
"I''d rather be a conservative nut job than a liberal with no nuts and no job."

Edited on 8/30/2008 6:18 AM

i would take the rival to like 1000 abralon.......   that should make it roll a lil earlier and still have a nice pop on the back end
--------------------
"USAbowlersmart.com - only the best Survive"