win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Short Pin Full Swing - High Track Player Layout?  (Read 1142 times)

rkj4243

  • Full Member
  • ***
  • Posts: 155
Short Pin Full Swing - High Track Player Layout?
« on: October 05, 2009, 06:55:36 AM »
Have a short pin Full Swing, 1 - 1.5" pin, looking for help with a smooth, arcing type layout for this piece. My specs are: PAP - 5 1/4" over 0 up or down, speed about 16 mph, low axis tilt, medium axis rotation, abouty 250 - 275 rpm's. Looking for something smooth and arcing, I do plan to polish this ball a little to help it get farther down the lane, and will use it on a fresh condition with clean backends before transition starts. Any help or suggestions will be appreciated.
Logged

 

bluerrpilot

  • Hero Member
  • *****
  • Posts: 1235
Re: Short Pin Full Swing - High Track Player Layout?
« Reply #1 on: October 05, 2009, 03:10:20 PM »
Pin down and mb in the 45-50degree range should make it smooth. If using a dual angle to lay it out, Id say 45-50degx5"x40-45deg. I would not polish it yet though, it gets decent length and is very clean through the fronts allready. Adding surface to it would be better for making it smooth and polishing it could make it jumpy.
--------------------
"USBC is concerned that technology has overtaken player skill in determining success in the sport of bowling"

http://www.phxbowling.com/acba
http://www.viseinserts.com/

Edited on 10/5/2009 3:10 PM
Logged

NoseofRI

  • Hero Member
  • *****
  • Posts: 567
Re: Short Pin Full Swing - High Track Player Layout?
« Reply #2 on: October 05, 2009, 03:17:16 PM »
Fully agree with the layout above.  On a little bit more volume this ball should get through the heads very easily, so I also don't see a need to polish.  If its a little too early on you first try hitting the cover with a fresh 4000 abralon pad before trying polish, it'll give the ball a nice smooth surface and add a bit of a sheen to it.
Logged
Pages: [1]
« previous next »