BallReviews
General Category => Coverstock Preparation => Topic started by: JohnN on November 10, 2010, 07:25:28 AM
-
Do those of you with spinners do 4 or 6 sides when sanding ? If 4 what are your steps. I start with the finger hole up.
-
From all of my experience with resurfacing and attaining the out of box performance.....for small surface adjustments you really only need to do two sides. When resurfacing you can do two sides, but then rotate the ball 90 degrees when you go to the next grit to maintain a perfect sphere.
Unless you need a crosshatch for a heavy condition, 4 or 6 sides is not really needed.
-Kevin
--------------------
www.ValentinoBowling.com
makers of Snake Oil, Remedy RX, Resurrection & UFO
Premium Maintenance Products