win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Best surface for a Track Power Machine  (Read 1550 times)

Buckwild

  • Hero Member
  • *****
  • Posts: 1038
Best surface for a Track Power Machine
« on: June 12, 2009, 04:19:19 AM »
Which abralon pad is best to use for this ball? Also I have Resurrection, Snake Oil and UFO. I dont have a spinner, I'm doing this by hand.

Edited on 6/12/2009 3:08 PM
Logged

 

ValentinoBowling

  • Hero Member
  • *****
  • Posts: 801
Re: Best surface for a Track Power Machine
« Reply #1 on: June 18, 2009, 10:55:11 AM »
I would recommend using Resurrection to give the ball an 800 grit surface and then apply Snake Oil. By hand it might take a little time but just make small circles until you've covered the ball.

-Kevin
--------------------
www.ValentinoBowling.com
makers of Snake Oil, Remedy RX, Resurrection & UFO
Premium Maintenance Products
Logged

Buckwild

  • Hero Member
  • *****
  • Posts: 1038
Re: Best surface for a Track Power Machine
« Reply #2 on: June 18, 2009, 11:10:50 AM »
Thanks Kevin! When I sent my post, I didn't recieve any responses, so I went ahead and did exactly what you recommended. I bowl league tonight, so I will see how it turned out. Also, I used Resurrection only on my Epic Battle. How should that work on the lanes?
Logged

ValentinoBowling

  • Hero Member
  • *****
  • Posts: 801
Re: Best surface for a Track Power Machine
« Reply #3 on: June 18, 2009, 11:28:28 AM »
The balls grit listed on 123bowl.com says 800 grit machine sanded, so your going to duplicate the out of box surface and reaction.

-Kevin
--------------------
www.ValentinoBowling.com
makers of Snake Oil, Remedy RX, Resurrection & UFO
Premium Maintenance Products
Logged

Buckwild

  • Hero Member
  • *****
  • Posts: 1038
Re: Best surface for a Track Power Machine
« Reply #4 on: June 18, 2009, 12:14:40 PM »
Thanks again! If I'm on a medium THs and have to play inside, will the OOB for the Battle be too much? What would be the best surface ajustment, if needed? I have medium revs and speed.
Logged

ValentinoBowling

  • Hero Member
  • *****
  • Posts: 801
Re: Best surface for a Track Power Machine
« Reply #5 on: June 18, 2009, 04:11:02 PM »
It all depends on how long the oil is laid. For medium conditions I always recommend a Pearl and a Particle. The Pearl finished with Snake Oil and the Particle at Resurrection (spun on a spinner, so it has a sheen finish).

Personally this is my method for attacking a medium lane condition:
Starting off with the Pearl, the oil will transistions slower for me and provides a good angle to the pocket. Around the 3rd/4th frame of the second game, I switch over to the 800 sheen particle and continue of the same line. The dull surface will carry more oil down and create a buffer so on the middle of the 3rd and the 4th game I can take out the pearl and move right and play a stroker line up 10 which has a hold created by the particle ball. It works for me and a few others who I've practiced with.

-Kevin
--------------------
www.ValentinoBowling.com
makers of Snake Oil, Remedy RX, Resurrection & UFO
Premium Maintenance Products
Logged
Pages: [1]
« previous next »