Good Sunday afternoon to the BR Family,
It has been a good 2-3 weeks since I acquired a Vertex Personal Spinner.
I am having a blast with it so far!
Just one thing though...Resurfacing a ball and still seeing some bad sanding lines (especially after applying polish).
I took an Ebonite Xcel and hit it with these pads in the order below...
Brown - 320
Burgundy - 400
Green - 600
Gray - 800
White - 1200/1500
Notice, I didn't have a blue pad (1000 grit) handy and had to skip up to a White pad.
I noticed that after each pad use, I was still seeing sanding lines from the previous grit. I sanded each side with equal amount of time.
I even made sure to spray the ball with water and keeping the ball wet while I was applying pressure with each pad.
After the white pad, I hit the ball with Ebonite Factory Polish on a Terry Cloth towel. This made the sanding lines stand out even more.
Help! What am I doing wrong!?
From the Resurfacing Novice,
Ram
--------------------
Food is good for you!
