win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Polished ball, bit too skiddy. How to...?  (Read 2187 times)

Shermster

  • Full Member
  • ***
  • Posts: 217
Polished ball, bit too skiddy. How to...?
« on: April 07, 2009, 05:04:01 AM »
Touched up my C300 Momentum last night.

Clean and Dull, then applied light coat of polish by hand. Went to bowl last night and found the ball skidded a bit too long and about 3-5 board right of target.

How can I reduce length a tad? Use clean and dull again to remove some of the shine? Or go bowl on some fried lanes to burn off the polish? I don't want to adjust the cover stock with pads or scotch-brite.

Looking for some advice.
Thanks!
Logged

 

Dan Belcher

  • Hero Member
  • *****
  • Posts: 3954
Re: Polished ball, bit too skiddy. How to...?
« Reply #1 on: April 07, 2009, 01:08:07 PM »
Just FYI, Clean and Dull is a bit of a misnomer.  It won't actually dull the ball.  It also, however, won't shine it up, hence the name.
Logged

rockerbowler18

  • Hero Member
  • *****
  • Posts: 1352
Re: Polished ball, bit too skiddy. How to...?
« Reply #2 on: April 07, 2009, 01:08:09 PM »
When I get a ball that's a little overpolished and I don't want to take it all the way down to say, 4000 with an abralon pad, I just bowl with it until I get a track burnt into it. I think this actually gives me a little more consistent roll, and it's how I used to fix the surface on The One for a long time.

4000 + Ebonite factory finish polish + 10-15 games gave it a nice track and a smooth roll, but kept the finish that the polish gave it.
--------------------
JAT Junior Amateur Tour

Robb's Pro Shops: Bakersfield, California

Rob Stone Supporters of America!

Only Studs Wear Argyle http://i86.photobucket.com/albums/k116/rockerbowler18/MikeFagan.jpg
Logged

  • Guest
Re: Polished ball, bit too skiddy. How to...?
« Reply #3 on: April 07, 2009, 02:44:33 PM »
You can also try a little more surface underneath the polish.


--------------------
Lane Carter, Strike Zone Pro Shops - Salt Lake City, Utah
Brunswick Pro Shop Staff

www.brunswickbowling.com

The opinions expressed are solely those of the writer and not of Brunswick Corporation.
Logged
Pages: [1]
« previous next »