win a ball from Bowling.com

Author Topic: Removing polish  (Read 2391 times)

R-Zitro

  • Full Member
  • ***
  • Posts: 176
Removing polish
« on: April 14, 2017, 10:02:31 PM »
Just purchased a United revolt, I am 65 and the ball is just to strong for me.
When I put some polish on it to get it down the lane if I don't like it that way
Is there an easy way to take it off

 

Aloarjr810

  • Hero Member
  • *****
  • Posts: 2149
  • Alley Katz Strike!
Re: Removing polish
« Reply #1 on: April 14, 2017, 10:07:26 PM »
Just purchased a United revolt, I am 65 and the ball is just to strong for me.
When I put some polish on it to get it down the lane if I don't like it that way
Is there an easy way to take it off

Sure sand it, simple as that.  Abralon pads, Siaair pads, sandpaper .

Aloarjr810
----------
Click For My Grip

leftybowler70

  • Hero Member
  • *****
  • Posts: 1710
Re: Removing polish
« Reply #2 on: April 14, 2017, 10:15:08 PM »
Use a 4000 grit pad (wet sand) That way the polish is removed while giving you a ball that will still get down the lane before it reads and reacts.... Remember, that the rougher the surface, the earlier it reads the lane.

You mentioned wanting a cleaner ball motion; 4000 grit pad.

charlest

  • Hero Member
  • *****
  • Posts: 24526
Re: Removing polish
« Reply #3 on: April 15, 2017, 04:40:55 AM »
Remember that polish is not a coating like varnish or lacquer or polyurethane. It is an extremely fine abrasive. Most polished balls, with a shined or gloss appearance, have roughly a surface with the equivalent of 4500 - 5500 grit. Removing "polish" is the equivalent of reducing the grit level to a lower number. The shined appearance will become a matte (dull) appearance. The highest grit that is usually available that will not result in a polished appearance is 4000 grit. Abralon, Siaair and Jost all make pads at this grit level.
"None are so blind as those who will not see."