Author Topic: Two different pads at once (Read 6564 times)

lefty50 · « **on:** August 08, 2014, 09:27:37 PM »

I was told something last week that is difficult to believe...
What is the net effect of using two different grits simultaneously on a ball with a spinner?

scotts33 · « **Reply #16 on:** August 11, 2014, 03:38:41 PM »

To add to this I don't think you can correct surfaces using a spinner vs. a Haus machine. rpm's are way higher on a spinner vs. Haus.

I could see starting at 360 via spinner to take out tracking etc when resurfacing/de-oiling. But subsequent layers should be done by hand to better replicate a surface IMO. I'd like to see a scanner result of spinner vs. by hand.

kidlost2000 · « **Reply #17 on:** August 11, 2014, 06:41:16 PM »

No way I personally would do that by hand. Using a spinner and covering 6 sides with each grit as I go up looks really good when finished. It looks as close to a factory finish as I have seen.

BrunsNick · « **Reply #18 on:** August 11, 2014, 06:58:50 PM »

I've never heard of this. Seems like a waste to me.

Author Topic: Two different pads at once (Read 6564 times)

lefty50

Two different pads at once

scotts33

Re: Two different pads at once

kidlost2000

Re: Two different pads at once

BrunsNick

Re: Two different pads at once