win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: best surface for dirty bomb  (Read 1613 times)

APheLion

  • Hero Member
  • *****
  • Posts: 1367
best surface for dirty bomb
« on: January 26, 2010, 03:58:31 AM »
i have tried couple of finish, but the ball hits like a potato...

it was ok when it was OOB, but after that its pretty much dead... it doesnt even have that many games on it

whats would be the best? 2000 + polish?
--------------------
When a house bowler misses the mark, misses the break point and strike, for many ppl its called a wallshot. When a pro does that its call adjustment

When a house bowler gets his finger stuck in the ball and fall on the lanes, for many ppl its called lame bowler. When a pro does that its called the Machuga flop! ha i like this one.
Logged

 

Sir Bowl-A-Lot

  • Hero Member
  • *****
  • Posts: 2981
Re: best surface for dirty bomb
« Reply #1 on: January 26, 2010, 12:06:12 PM »
Dirty Bomb?  That sounds like something one leaves in the toilet after eating Bell Taco...
Logged

APheLion

  • Hero Member
  • *****
  • Posts: 1367
Re: best surface for dirty bomb
« Reply #2 on: January 26, 2010, 10:38:10 PM »
yea but that was still made in usa, not yet mexicano yet my friend
--------------------
When a house bowler misses the mark, misses the break point and strike, for many ppl its called a wallshot. When a pro does that its call adjustment

When a house bowler gets his finger stuck in the ball and fall on the lanes, for many ppl its called lame bowler. When a pro does that its called the Machuga flop! ha i like this one.
Logged

dizzyfugu

  • Hero Member
  • *****
  • Posts: 7606
Re: best surface for dirty bomb
« Reply #3 on: January 27, 2010, 01:37:36 AM »
That one has a Brunswick cover, if I remember correctly? Do you know which one? Could it be Activator+? Then I'd recommend a thorough oil extraction, and then apply Brunswick's Rough Buff compound or a 4.000 grit Abralon surface.

Additionally, are you sure that the drilling is O.K., and that the ball reacts properly? A change of PAP could have affected the setup, so that the ball does not react the same anymore - another potential (though hardly to expect) source for your problem.
--------------------
DizzyFugu - Reporting from Germany

Confused by bowling? Check out BR.com's vault of wisdom: the unofficial FAQ section
Logged
DizzyFugu ~ Reporting from Germany
Pages: [1]
« previous next »