BallReviews

General Category => Drilling & Layouts => Topic started by: cooksey on October 26, 2004, 05:00:45 AM

Title: 1:30 drilling on thing lives help
Post by: cooksey on October 26, 2004, 05:00:45 AM

Hello all you drillers out there. I have one of these balls that I bought used and was considering putting this drill on it. What kind of reaction should I expect to get? Also I could just shift the finger holes and end up with pin beside the ring finger and cg kicked out from center about an inch which would be better. Any help appreciated.

Thanks, cooksey
--------------------
" Focus the next shot is critical"

Edited on 10/26/2004 1:02 PM

Title: Re: 1:30 drilling on thing lives help
Post by: cooksey on October 26, 2004, 01:07:19 PM

ttt didn't see it on the list.

cooksey
--------------------
" Focus the next shot is critical"

Title: Re: 1:30 drilling on thing lives help
Post by: JohnP on October 26, 2004, 03:12:34 PM

cooksey -- The link below will take you to index page of Mario's Secrets on the Rollrite website.  In the section on the 315 degree layout, you will find a drawing that shows the various layout schemes and their reaction characteristics.  There's a lot of other good info that can be accessed from that index page also.  --  JohnP

http://www.rollrite.co.uk/secrets.php