Author Topic: 811A SE drilling layout? (Read 1581 times)

ten on the deck · « **on:** January 04, 2012, 12:20:20 PM »

I currently have a 718A drilled with a dual thumb layout (I believe my driller said it was a 60 x 30?) Has a weight hole just to the right of my thumb hole (RHB)
I Have an 811A on order & looking for any suggestions on a layout for this ball. I am looking for it to get into a roll a bit sooner than the 718A when the 718 is going too long. I love the way the 718A rolls with the dual thumb layout but not sure if the two balls would be to close in motion if I have the 811A drilled to the same layout.
thanks for the input.

Thanks for any help.

Ten on the Deck.......
"Never confuse activity with accomplishment"
Gene Stallings

JohnP · « **Reply #1 on:** January 05, 2012, 10:35:34 AM »

The double thumb layout is the strongest available, that means it rolls very early. You'll have to use surface adjustments to get the 811A to roll earlier. -- JohnP

Author Topic: 811A SE drilling layout? (Read 1581 times)

ten on the deck

811A SE drilling layout?

JohnP

Re: 811A SE drilling layout?