win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Adjusting reaction w/X-hole  (Read 1212 times)

Trackoholic

  • Full Member
  • ***
  • Posts: 202
Adjusting reaction w/X-hole
« on: March 08, 2006, 04:01:54 AM »
I have a Robo Rule drilled:

-O-O-
-----o---Pin
-----.---CG
-----
--O--
-----
----MB---Mass Bias

This ball has a 2 inch pin
I am slightly speed dominant over revs and this layout
is giving me more backend than I can control.  Does
anyone have any suggestions to tame the backend with
a weight hole in a specific placement.  Size, depth.
My thoughts were to achieve more flare to burn up a
little sooner.
Logged

 

rickc

  • Jr. Member
  • **
  • Posts: 90
Re: Adjusting reaction w/X-hole
« Reply #1 on: March 08, 2006, 01:24:28 PM »
How much side weight does it have? I just added side weight to my V2 to get it to finish stronger.  Taking some out should soften the backend a bit.
--------------------
Rick
Logged

Trackoholic

  • Full Member
  • ***
  • Posts: 202
Re: Adjusting reaction w/X-hole
« Reply #2 on: March 09, 2006, 09:42:28 PM »
I thought a hole on the pap would stablize the ball early saving more energy for the backend.  Did I misunderstand?
Logged

proshopbowl

  • Jr. Member
  • **
  • Posts: 78
Re: Adjusting reaction w/X-hole
« Reply #3 on: March 11, 2006, 01:31:58 AM »
Drill both fingers deeper. This will reduce the diff.
 or
Drill a weight hole 2 inches inside your VAL 7/8 in diameter, taking the static weights between 0 and 1/2 negitive. This will give you more midlane roll.
--------------------
You like apples? How do you like these apples?
Logged
Pages: [1]
« previous next »