I have a 900 Global Inception Redux that I'm considering a layout of 30* x 5 x 50*. My PAP is 5 1/2" x 1" up. This puts the pin right above the ring finger almost in the ring finger. The CG 2 7/8" from the PAP and it puts the Mass Bias about 1/2" right of the VAL for a right hander. The reaction I'm looking for is something that will rev up early in heavy oil (sport conditions) be continuous and have a strong arc on the back.

I know MB close or on the VAL will create hook stop kind of reaction what can I expect from this layout.

Thanks, Pete

All the reviews say that the ball goes further than the Inception and hooks later down lane. I want it to hook more in the mid-lane and continue. So for a higher volumes of oil (sport patterns) will this drilling do that. I want to take the coverstock out of the equation I'm specifically asking about the characteristics of the layout only. Layout should rev up early and volume of oil should cause ball to retain the energy enough until it hits the pocket without burning up.

Of course they're going to say that. I'm not a staffer, just someone who is well versed in 900 Global ball reaction. I hope it works out for you.

Of course they're going to say that. I'm not a staffer, just someone who is well versed in 900 Global ball reaction. I hope it works out for you.

I look at a variety of reviews not just from staffers and most all say that because of the core alteration and hybrid cover that this ball goes further down the lane before it makes it's transition. So my thinking is shorter drill angle will be offset by the longer pin distance along with Val angle of 50* will bleed off the break point over the whole lane. The volume of oil and surface adjustment if needed will offset the ball burning up early. Just to clarify I'm not a high rev guy (power stroker 325-350 rpm) and this ball will be condition specific ( long sport patterns).