win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Pin-axis drilling------Pin-in or pin-out?  (Read 3075 times)

Juggernaut

  • Hero Member
  • *****
  • Posts: 6498
  • Former good bowler, now 3 games a week house hack.
Pin-axis drilling------Pin-in or pin-out?
« on: March 27, 2012, 07:36:24 PM »
If you were going to drill a pin-axis ball, would it be better to use a pin-in ball, or a pin-out ball?

 

Would it make any difference, except for the need/placement of a weight hole?
Logged
Learn to laugh, and love, and smile, cause we’re only here for a little while.

 

Strider

  • Hero Member
  • *****
  • Posts: 6759
Re: Pin-axis drilling------Pin-in or pin-out?
« Reply #1 on: March 27, 2012, 10:24:01 PM »
Unless it's a very low top weight ball, I'd assume you'd want a decent pin out so the CG could be somewhat close to your grip center so you wouldn't necessarily need a monster weight hole.



Ron Clifton's Bowling Tip Archive
Logged

Juggernaut

  • Hero Member
  • *****
  • Posts: 6498
  • Former good bowler, now 3 games a week house hack.
Re: Pin-axis drilling------Pin-in or pin-out?
« Reply #2 on: March 27, 2012, 11:12:23 PM »

  Well, I have access to both. I have a ball with a 4 1/4 pin out oz top (my pap is 4 1/8>), and a ball with pin in and 1.75oz top.

 

 I also have access to a couple of balls with 3-3.5 pins and around 3 top.



Strider wrote on 3/27/2012 8:24 PM:
Unless it's a very low top weight ball, I'd assume you'd want a decent pin out so the CG could be somewhat close to your grip center so you wouldn't necessarily need a monster weight hole.



Ron Clifton's Bowling Tip Archive
Logged
Learn to laugh, and love, and smile, cause we’re only here for a little while.

JustRico

  • Hero Member
  • *****
  • Posts: 2652
Re: Pin-axis drilling------Pin-in or pin-out?
« Reply #3 on: March 27, 2012, 11:22:22 PM »
depending on the starting differential, a pin within 1/2-1" of the PAP will react the same as placing the pin in the PAP. My suggestion would be to place the pin 1/2-1" to PAP and not risk inverting the flare.


The views and opinions expressed by myself are solely those of mine and NO one else, nor are they affiliated with anyone else.
Logged
Co-author of BowlTec's END GAMES ~ A Bowler's COMPLETE Guide to Bowling; Head Games ~ the MENTAL approach to bowling (and sports) & (r)eVolve
...where knowledge creates striking results...
BowlTEc on facebook...www.iBowlTec.com

JohnP

  • Hero Member
  • *****
  • Posts: 5819
Re: Pin-axis drilling------Pin-in or pin-out?
« Reply #4 on: March 28, 2012, 02:48:31 PM »
I agree with justrico, and I suggest a ball that will give you about 3/4 oz of positive side weight after drilling so you can use a balance hole to adjust the reaction if desired.  --  JohnP


Logged
Pages: [1]
« previous next »