Author Topic: asym flip drilling question (Read 1102 times)

stormerjip · « **on:** June 25, 2008, 01:34:49 PM »

i know this might sound weird but if i lay out a symetrical ball with with same measurements and imaginary mb same as asym ball with asym flip drilling how are the two going to compare similar ball characteristics and everything
--------------------
show no mercy, kill the wounded, eat the dead

Edited on 6/25/2008 9:35 PM

Corey C · « **Reply #1 on:** July 01, 2008, 12:22:50 AM »

Which Assym flip drill are you referring to?
--------------------
Corey Clayton
Brunswick Amateur Staff
Turbo Grips Staff
Team Canada 2007, 2008, & 2009

stormerjip · « **Reply #2 on:** July 01, 2008, 12:37:50 AM »

i ddint know there was more than one i have it on a file and its call me's asym flip drilling
--------------------
show no mercy, kill the wounded, eat the dead

Corey C · « **Reply #3 on:** July 01, 2008, 11:33:04 PM »

A typical flip drill would be a 5.5" pin high and the MB at 45 degrees. However, on an Assym a 2" pin is also considered a flip drill because it keeps the flare rings tight, and down lane the strength of the core will make it flip. On a symm it also keeps the rigns tight BUT the core is so stable it just rolls.
--------------------
Corey Clayton
Brunswick Amateur Staff
Turbo Grips Staff
Team Canada 2007, 2008, & 2009

Author Topic: asym flip drilling question (Read 1102 times)

stormerjip

asym flip drilling question

Corey C

Re: asym flip drilling question

stormerjip

Re: asym flip drilling question

Corey C

Re: asym flip drilling question