win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Asymmetric Drilling options  (Read 1525 times)

vagabond

  • Full Member
  • ***
  • Posts: 105
Asymmetric Drilling options
« on: October 22, 2006, 10:21:14 AM »
Ok simple question if I am going to get the reaction I want from this drilling. This will be on a strong Pearl Reactive ball with a strong MB influence.  Possibly the Epic Saga, Paradigm Domination, or maybe a Vapor Zone.  Leaning towards the Domination.  Stats in profile.

Drilling 5"x3" (pin/MB to pap) with a 3 1/2" pin buffer with an extra hole on the VAL.  Or maybe the MB on or past the VAL with the 5"x3"

Will this give me the length I want through the heads with a good midlane roll but not the complete left turn of a 4"x4" or a stronger MB location? I think it will but I wanted others opinions on the matter.

All other options appreciated.
Logged

 

charlest

  • Hero Member
  • *****
  • Posts: 24526
Re: Asymmetric Drilling options
« Reply #1 on: October 23, 2006, 11:42:22 AM »
That drill has the potential to do what you want, given the appropriateness of the ball and its surface to the oil pattern AND your release/delivery.
--------------------
"None are so blind as those who will not see."
Logged
"None are so blind as those who will not see."

DanH78

  • Hero Member
  • *****
  • Posts: 3913
Re: Asymmetric Drilling options
« Reply #2 on: October 23, 2006, 11:52:15 AM »
Hijack time...what's a "pin buffer"?

--------------------
What are you gonna do?  Beat me with your Jesus stick?
Logged
#10

vagabond

  • Full Member
  • ***
  • Posts: 105
Re: Asymmetric Drilling options
« Reply #3 on: October 23, 2006, 12:03:31 PM »
Thanks Charlest for the confirmation of my thoughts, I understand about the surface prep and release that will be needed and I will take care of that.

Pin buffer is Storms way of actually giving a measurement of where to locate the RAD in location to the VAL and it also affects the pin height

Edited on 10/24/2006 0:06 AM
Logged
Pages: [1]
« previous next »