BallReviews

General Category => Drilling & Layouts => Topic started by: REVOLUTIONS PS on January 16, 2004, 03:39:05 AM

Title: Ball drillers: Proceedure for pin in track Q
Post by: REVOLUTIONS PS on January 16, 2004, 03:39:05 AM

I am considering drilling a low flare Stinger with the pin in my track.  I am wondering whether any of you have a certain procedure for that drill pattern.  Do you place the pin 6 3/4" from your axis and measure back or do you have a measurement from your track to the midline?  Any thoughts would be appreciated.  I am drilling this ball with the intention of using it from outside angles on dry to very dry.  Thanks.

Title: Re: Ball drillers: Proceedure for pin in track Q
Post by: TheDude on January 16, 2004, 09:49:42 PM

could try and shift your cg into the negative side of your centerline as well. helps to kill the backend a bit too.
--------------------
I am Canadian Dude! GOO BIG FIN!!! MIKA K ALL THE WAY!