BallReviews
General Category => Drilling & Layouts => Topic started by: mw11x300 on February 26, 2008, 02:18:25 AM
-
Looking for some layout and cover prep suggestions on a Mammoth. I'm drilling it more or less as a condition specific piece for heavier flatter conditions such as the BTM and USBC Nationals. I'm looking to have something for the early games to help burn a spot outside to later bump off of. I'm a bit speed dominant now days and my rev rate has fallen off to about 300 due to some injuries. PAP is 5.5 right 3/4 up favorite layouts are usually 5 x 60* and 4.5x45* if that is of any help. Looking for some of the Big B guys to chime in here as I'm not really familiar with any of the product last piece I had was a Brimstone Monster which I loved on the soup.
-
a dozen views and no replies what all the BrunsBoys still sleepin??
-
Mine is drilled about 4" from PAP below the fingers, small balance hole needed.
I'm not speed dominant (16mph) but this ball handles LOTS of oil. I have changed the surface to 2000 abralon to make to suit my game better. Factory surface just about started hooking immediately so I had to adjust it. As with most heavy load particle balls, I don't cross as many boards as I would with a reactive, but on the "soup" the ball can be pretty good. Good luck.
On edit, I did try some polish but didn't like it as much as 2000 abralon.
--------------------
Lane Carter, Strike Zone Pro Shops - Salt Lake City, Utah
Brunswick Amateur Staff
Edited on 2/26/2008 1:57 PM
-
http://www.ballreviews.com/Forum/Replies.asp?TopicID=182484&ForumID=2&CategoryID=2
http://www.ballreviews.com/Forum/Replies.asp?TopicID=185903&ForumID=2&CategoryID=2
--------------------
3 holes of fun!!
-
Rico the bad boy...
-
Kinda surprised that wasn't the first suggestion seeing as there are a hundred posts a month about that layout.