BallReviews

General Category => Drilling & Layouts => Topic started by: tekneek on August 19, 2005, 03:50:16 AM

Title: CONVERSION CHART
Post by: tekneek on August 19, 2005, 03:50:16 AM

Did I see a conversion chart posted here that based off of your pap you can cross reference your axis tilt and track diameter?

5-3/8 over 3/8 up would be 11-15* tilt and track diameter of 11-1/4 ?
the above is an example not a for real deal.

Title: Re: CONVERSION CHART
Post by: pagnouch on August 19, 2005, 12:10:50 PM

ttt
--------------------
Champions Train-Losers Complain!!

Title: Re: CONVERSION CHART
Post by: JohnP on August 20, 2005, 07:13:58 PM

tekneek -- The link below takes you to a chart within the asymmetrical ball layout section at buddiesproshop.com.  The heading of the chart says "Track circumference versus tilt", but what you actually use is the circumferential diameter (the diameter of the track measured across the surface of the ball).  There's another section at buddies that shows how to measure that.  The relationship is between track diameter and tilt, the PAP has nothing to do with it.  --  JohnP