Author Topic: Core Power HRG Drilling Wet/Dry (Read 1171 times)

rollingthunder · « **on:** November 05, 2003, 07:14:55 PM »

Any suggestions on drilling a Core Power HRG (2-3" pin)
for wet/dry conditions? I throw about 16mph, low track and
above average revs.

Thanks

Edited on 11/6/2003 11:29 AM

TheDude · « **Reply #1 on:** November 06, 2003, 01:25:06 PM »

Drill the ball with the pin 2 inches from axis and balance the ball with a weight hole around 5 1/2 to 6 inches from the centre of the grip through the CG. and change your cover to 1000 wet sand. i've seen this used on a wall shot by a house proshop owner on storm staff with a low track and high rev rate, worked wonderfully for him. It was on a very wet dry block shot.
--------------------
I am Canadian Dude!

Author Topic: Core Power HRG Drilling Wet/Dry (Read 1171 times)

rollingthunder

Core Power HRG Drilling Wet/Dry

TheDude

Re: Core Power HRG Drilling Wet/Dry