BallReviews
General Category => Drilling & Layouts => Topic started by: Iketown300 on June 20, 2004, 06:29:02 AM
-
What would this layout give me? 2 1/2" pin to pap, 1 7/8" above the midline, and the distance from the pin to the mass bias is 7 1/2"? I heard it was a good drilling for control. Also has anybody ever drilled a ball where your pin was on your pap? If you have what kind of reaction did you get? also what was the actual drilling 0 X what? or anyone ever do the reverse such as 3 X 0, or 5 X 0?
--------------------
Ike Brownfield
-
I saw this on morich's website for a control drilling medium rev rate for the hercules. The RC was 7 1/2" away from the PAP i thought i will check again to make sure.
--------------------
Ike Brownfield
-
This is what the morich site says for a control drilling on a hercules ball...
The PIN to Mass bias position was 7 1/2" the PAP to Mass bias was 6 1/4".
--------------------
Ike Brownfield
Edited on 6/21/2004 8:05 PM