Ok, hopefully easy question in the hopefully right forum...  

 

 

I have a Dremel. I'd like to add the right accessories to have the ability to attach a sanding disc and do minor widening as done in pro shops. I can't seem to find a long enough extension rod, and not completely sure about the sanding discs, although I do see 1-1/4 inch options on Ebay.

 

Does anyone else use a Dremel for this? Can you tell me where to find a long enough extension rod and discs?

 

Thanks in advance

 

I have a 7/8 inch and a 1/2 inch dowel rod with 120 self stick sandpaper on both ends.  Tthe different diameters allow me to custom sand my milled thumb holes or oval inserts precisely where I need to.   I also cut my dowel rods to about 12 inches in length which comes in handy when I want to carry them in my bag when I need to "fine tune" the thumb hole fit on new balls.  It works great and my total cost was less than 10 bucks!!!

 

My other comment would be that the dowel rods are faster than you might think at removing material.  That said, I would be cautious of the dremel removing too much material too quickly and causing the thumb hole to be too big.  

 

Just my 2 cents.

 

MK