Author Topic: Drilling a Bonanza blem and have a couple of questions (Read 1142 times)

jkiser01 · « **on:** January 20, 2005, 03:37:01 PM »

I bought one of the Bonanza blems Beans had and was curious do I have to find the mass bias when drilling this ball or does it even matter? Its a backyard bully. I also can't find the cg marking but I'm sure my pro shop guy can find that.

any help would be appreciated..

--------------------
If they only made a ball that would carry that da_n 7 pin (and I am right handed!!)

jkiser01

thfonz98 · « **Reply #1 on:** January 20, 2005, 11:57:32 PM »

find the cg and cross your fingers and hope the m.b. is in line with it.... i guess
--------------------
"Joey . . . have you ever seen a grown man naked?"-Captain Clarence Oveur

J_Mac · « **Reply #2 on:** January 21, 2005, 12:07:39 AM »

quote:
find the cg and cross your fingers and hope the m.b. is in line with it.... i guess

Or find a proshop with a determinator and hopefully find the MB (if it's strong enough) and then not worry as much about the CG. (Which is easily found on the scales anyhow.)

--------------------
Everyone is entitled to be stupid but you're abusing the privilege.

jkiser01 · « **Reply #3 on:** January 21, 2005, 05:48:48 AM »

My pro shop guy does not have a determinator so I guess I will go with plan A, find the CG and hope the MB is in line with that..
--------------------
If they only made a ball that would carry that da_n 7 pin (and I am right handed!!)

jkiser01

Author Topic: Drilling a Bonanza blem and have a couple of questions (Read 1142 times)

jkiser01

Drilling a Bonanza blem and have a couple of questions

thfonz98

Re: Drilling a Bonanza blem and have a couple of questions

J_Mac

Re: Drilling a Bonanza blem and have a couple of questions

jkiser01

Re: Drilling a Bonanza blem and have a couple of questions