BallReviews

General Category => Drilling & Layouts => Topic started by: jkiser01 on January 20, 2005, 03:37:01 PM

Title: Drilling a Bonanza blem and have a couple of questions
Post by: jkiser01 on January 20, 2005, 03:37:01 PM
I bought one of the Bonanza blems Beans had and was curious do I have to find the mass bias when drilling this ball or does it even matter? Its a backyard bully. I also can't find the cg marking but I'm sure my pro shop guy can find that.

any help would be appreciated..


--------------------
If they only made a ball that would carry that da_n 7 pin (and I am right handed!!)

jkiser01
Title: Re: Drilling a Bonanza blem and have a couple of questions
Post by: thfonz98 on January 20, 2005, 11:57:32 PM
find the cg and cross your fingers and hope the m.b. is in line with it.... i guess
--------------------
"Joey . . . have you ever seen a grown man naked?"-Captain Clarence Oveur
Title: Re: Drilling a Bonanza blem and have a couple of questions
Post by: J_Mac on January 21, 2005, 12:07:39 AM
quote:
find the cg and cross your fingers and hope the m.b. is in line with it.... i guess


Or find a proshop with a determinator and hopefully find the MB (if it's strong enough) and then not worry as much about the CG.  (Which is easily found on the scales anyhow.)

--------------------
Everyone is entitled to be stupid but you're abusing the privilege.
Title: Re: Drilling a Bonanza blem and have a couple of questions
Post by: jkiser01 on January 21, 2005, 05:48:48 AM
My pro shop guy does not have a determinator so I guess I will go with plan A, find the CG and hope the MB is in line with that..
--------------------
If they only made a ball that would carry that da_n 7 pin (and I am right handed!!)

jkiser01