win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Drilling an Asymetrical Balll with CG off Centerline through MB and Pin  (Read 1785 times)

Brunswick_fan_BrandonH

  • Hero Member
  • *****
  • Posts: 786
Drilling an Asymetrical Balll with CG off Centerline through MB and Pin
« on: March 04, 2010, 11:11:27 PM »
I have a NIB Brunswick Blast Zone that has the CG approximately 1.5" to the right of the Pin to MB line.  The pin is about 3" from CG and top weight is approx 3oz.  I was thinking about using a dual angle drilling of 45 Deg x 4 1/2" x 45 Deg.  I am a right handed bowler and was wondering if there is anything special that I would have to do in order to make it legal.  Thank you in advance.
--------------------
Brunswick user and supporter.  Go Big B!
PBA Eastern Region Member
Logged
Vise Staff Member

 

stormed1

  • Hero Member
  • *****
  • Posts: 1755
Re: Drilling an Asymetrical Balll with CG off Centerline through MB and Pin
« Reply #1 on: March 05, 2010, 08:58:26 AM »
It in some ways will depend on how much top weight it has. If it has higher top weight it may end up with too much side weight too get out. Lay the ball out with your desired layout and then scale it before drilling. That will give you reults as the whether you can make it legal or not. Other than that possibility everything else should be fine
--------------------
Arsenal: Mega Friction,Break Point x 2, Break,Clutch,Clutch Pearl,Maniac,Awakening,Lunatic,Heist Pearl,SX-1,Link,Hype urethane,Global Globe, 14# golden globe

http://s485.photobucket.com/albums/rr220/stormed1/My%20Arsenal/
Bowlingboards.com
Logged
Current arsenal


Break Down 60x4.5x60 @3k+polish
coming soon X,Desert Ops,Special Ops, Shadow Ops., Truth Pearl ,Drift

Dave_in_Rio_Rancho

  • Sr. Member
  • ****
  • Posts: 471
Re: Drilling an Asymetrical Balll with CG off Centerline through MB and Pin
« Reply #2 on: March 05, 2010, 09:54:08 AM »
"stormed1:
Lay the ball out with your desired layout and then scale it before drilling. That will give you the results as to whether you can make it legal or not. Other than that possibility everything else should be fine."

+1
Logged

Brunswick_fan_BrandonH

  • Hero Member
  • *****
  • Posts: 786
Re: Drilling an Asymetrical Balll with CG off Centerline through MB and Pin
« Reply #3 on: March 05, 2010, 10:13:52 AM »
Thank you for the suggestion.  I will consult with my pro shop and pass along the information.
--------------------
Brunswick user and supporter.  Go Big B!
PBA Eastern Region Member
Logged
Vise Staff Member
Pages: [1]
« previous next »