Author Topic: Drilling for an Old Columbia Vector (Read 1571 times)

Toddace1 · « **on:** February 11, 2004, 09:10:33 PM »

Just wonder if anyone has any knowledge of how to drill up this ball, other than standard over the label. I haven't gotten the balls in yet, but I understand that they don't have a PIN marking. Any help would be apprechiated.

Thanks

michelle · « **Reply #1 on:** February 12, 2004, 12:24:34 PM »

Are you talking about the Vector One or the Vector Two. Seems to me the Vector One was black urethane while the Vector Two was sort of a navy urethane. Both used sort of a modified pancake core, with the block on the One being a little lower than traditional pancakes and the Two being even closer to the center of the ball.

I never had the Two, but I still have a One drilled basically straight label that will work on a down and in shot with decent carry.

nomanji · « **Reply #2 on:** February 16, 2004, 01:32:17 PM »

There's a special lay-out for the Vector 2 called "track weight". If I recall it correctly, drill out the CG using 1 1/4 drill bit, 3 inches deep. If you're RH, place your thumbhole at the arrow tip of Vector 2 engraving. For LH, place the ring finger on the arrow tip.

Author Topic: Drilling for an Old Columbia Vector (Read 1571 times)

Toddace1

Drilling for an Old Columbia Vector

michelle

Re: Drilling for an Old Columbia Vector

nomanji

Re: Drilling for an Old Columbia Vector