Looking for advice on any drilling layouts.
My pro shop operator drills all my balls
Pin up because any other drill pattern seems
To clip the thimb and fingers since I track
Very high. To get different reactions I
Normally use surface. Any ball layouts
Other than pin up that I could use with my
High track?

I track very very high.  Almost clip my thumb and 1 inch or soo off my fingers 16 mph 425 rev rate.   I always had the same problem with only having pin up up drillings.  My pap is also very unusual around 6 5/8 over and some. number up .  I request that i wanted a pin down bowling ball.  He ordered my venom cobra and paranoia with 2 inch pins and lower top weigh.  With the computer input we made it happen.      Most shops i walk into only have 3 to 4 inch pins which gives them the most flexability for drilling but almost impossible to do pin down for a high track.  Speak to him and see if he can order a shorter oin bowling ball for u.   He more than likely wants to sell stuff off the shelf with those long pins.

Quote from: Bowl_Freak on May 02, 2016, 10:37:52 AM

Pin stacked next to ring or any pin close to pap. Im the same, pin under layouts puke for me and roll over fingers cause the bowtie is so close.

I too track pretty high (PAP is 5 1/2 over).  But I put a weight hole down by my thumb to move that bowtie back away from the grip.  Had a Take Down drilled 50 x 5 x 70 which put the pin under my ring finger.  The 50 degree layout forced me to put a weight hole in it.  So putting it down moved the track back away from the grip.

I would follow TWOHAND's advice. He helped me a lot before I started testing different types of layouts.