BallReviews
General Category => Drilling & Layouts => Topic started by: johndc on May 02, 2016, 02:55:49 AM
-
Looking for advice on any drilling layouts.
My pro shop operator drills all my balls
Pin up because any other drill pattern seems
To clip the thimb and fingers since I track
Very high. To get different reactions I
Normally use surface. Any ball layouts
Other than pin up that I could use with my
High track?
-
Pin stacked next to ring or any pin close to pap. Im the same, pin under layouts puke for me and roll over fingers cause the bowtie is so close.
-
I track very very high. Almost clip my thumb and 1 inch or soo off my fingers 16 mph 425 rev rate. I always had the same problem with only having pin up up drillings. My pap is also very unusual around 6 5/8 over and some. number up . I request that i wanted a pin down bowling ball. He ordered my venom cobra and paranoia with 2 inch pins and lower top weigh. With the computer input we made it happen. Most shops i walk into only have 3 to 4 inch pins which gives them the most flexability for drilling but almost impossible to do pin down for a high track. Speak to him and see if he can order a shorter oin bowling ball for u. He more than likely wants to sell stuff off the shelf with those long pins.
-
Pin stacked next to ring or any pin close to pap. Im the same, pin under layouts puke for me and roll over fingers cause the bowtie is so close.
I too track pretty high (PAP is 5 1/2 over). But I put a weight hole down by my thumb to move that bowtie back away from the grip. Had a Take Down drilled 50 x 5 x 70 which put the pin under my ring finger. The 50 degree layout forced me to put a weight hole in it. So putting it down moved the track back away from the grip.
-
Pin stacked next to ring or any pin close to pap. Im the same, pin under layouts puke for me and roll over fingers cause the bowtie is so close.
I too track pretty high (PAP is 5 1/2 over). But I put a weight hole down by my thumb to move that bowtie back away from the grip. Had a Take Down drilled 50 x 5 x 70 which put the pin under my ring finger. The 50 degree layout forced me to put a weight hole in it. So putting it down moved the track back away from the grip.
I would follow TWOHAND's advice. He helped me a lot before I started testing different types of layouts.