It's done just like for an oval thumb, except you only move the press one direction instead of two.  Do you have digital on your press or is it just by inch measurements?  1/16 is way too far to move all at the same time, you're going to end up with ridges in the hole, if you have digital, I only go .021 per cut when I'm doing oval fingers, and if you have just the inch measurements, shoot for 1/32, the recommended max move when doing an oval hole is .033, so 1/32 would put you right under that. 

Quote from: sportsdruggie on July 03, 2017, 09:31:22 AM

Haha. Thanks for the quick response. That's what I was going to do. But I talked to a PSO and he said it had to do with reverse and side pitches. I just wanted toto make sure my thinking wasn't too far off lol. My intent was to go a drill bit smaller, punch 1 hole, then move jig over 1/16 and come down. Use dremel to smooth it out.