BallReviews

General Category => Drilling & Layouts => Topic started by: tc300 on November 24, 2009, 03:32:35 AM

Title: drilling the key out
Post by: tc300 on November 24, 2009, 03:32:35 AM

was just wonder'n if has drilled there thumb hole through the "key" on a VG or VE... if so what type of reaction did you see etc etc.

Title: Re: drilling the key out
Post by: jorr19 on November 24, 2009, 11:45:52 AM

i was told it enhances the reaction.
--------------------
Carry is not luck, it's physics.
In my bag... Rogue Cell, Virtual energy, rapid fire pearl, fast, furious, natural.

Title: Re: drilling the key out
Post by: John_Smith on November 24, 2009, 12:16:03 PM

Done this quite a few times on various assymetrics but not VG or VE. It rolls pretty good for me, I like it, quite sharp reactions compared to a bigger swing of the mass bias.

Title: Re: drilling the key out
Post by: tc300 on November 24, 2009, 12:50:18 PM

i am a high rev and speed player... low track some what of a spinner, i knew it would enhance the reaction... but would it make a VG stronger than it already is???  the 1 i have/had now i hate (pin under fingers cg kicked key on val)

Edited on 11/24/2009 1:52 PM

Title: Re: drilling the key out
Post by: Dave_in_Rio_Rancho on December 07, 2009, 08:03:46 PM

I have a ball drilled that way and it is long and then strong. Pin up then 4"  to PAP, key in thumbhole. Theoretically putting the key between the thumb and VAL would create a stronger overall ball with earlier read.

Title: Re: drilling the key out
Post by: tc300 on December 08, 2009, 02:09:18 PM

i just drilled a VE.... key through thumb and pin 1.5" from pap.    its pretty tame.