win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: dual angle drilling  (Read 3534 times)

rico4life

  • Full Member
  • ***
  • Posts: 227
dual angle drilling
« on: March 21, 2013, 11:52:14 PM »
I am planning on having my ball driller use the dual angle system for my next ball, question is does anyone have a picture of a mo pinel 10 degree drilling that replaces a axis leverage drilling. I just want to have some idea what it should look like, we want this ball to get into a roll very early for heavier conditions.
Logged

 

J_Mac

  • Hero Member
  • *****
  • Posts: 6778
Re: dual angle drilling
« Reply #1 on: March 22, 2013, 12:11:20 AM »
I'll look, but keep in mind every layout looks slightly different because everyone's axis point is not the same.

FWIW - If you have low tilt (10 degrees or less) my suggestion is to try the double thumb layout... if you have high tilt (20 degrees or more) the 10° drilling angle will be more appropriate.

That being said, any suggestion I'm giving is based on incomplete data... you haven't listed tilt, rotation, etc...

Below are 4 miscellaneous layouts with angles and pin to PAP distances.  First one on the left may be close to what you're after....
« Last Edit: March 22, 2013, 12:56:39 AM by J_Mac »
Logged

rico4life

  • Full Member
  • ***
  • Posts: 227
Re: dual angle drilling
« Reply #2 on: March 22, 2013, 10:58:17 AM »
thanks for the first picture, just wanted to know difference between axis leverage, and 10 degree. My ball driller wanted to do a axis leverage drilling for heavier oil, but mo says the 10 degree replaces axis leverage.
Logged

Impending Doom

  • Hero Member
  • *****
  • Posts: 6288
Re: dual angle drilling
« Reply #3 on: March 22, 2013, 12:10:13 PM »
It's the same thing.
Logged

Xcessive_Evil

  • Hero Member
  • *****
  • Posts: 1853
Re: dual angle drilling
« Reply #4 on: March 25, 2013, 02:27:36 AM »
Logged
Pages: [1]
« previous next »